** KNEE DRAGGERS UNITE ** Part VIII - I'm Stumped

[Dirk__Diggler]

Sup KDers.

After you make the thread post a link here and I'll lock it.


Isle of the misc........ thumbsup.gif

[6spdVQ]

Ride safe out there. Beautiful day in ny

[happylifter]

[recreateme]

Hey thread,

I am trying to replace my rearsets on my '08 Honda CBR125r - I have the replacement part all ready to go but i can't figure out how to remove the shifter arm from the rearset on the left side. Any chance someone knows how to remove it?

I thought maybe it would screw on, but nope, i think maybe its some kind of clip or something... I am stumped.

[Great_Story_Bro]

Hey thread,

I am trying to replace my rearsets on my '08 Honda CBR125r - I have the replacement part all ready to go but i can't figure out how to remove the shifter arm from the rearset on the left side. Any chance someone knows how to remove it?

I thought maybe it would screw on, but nope, i think maybe its some kind of clip or something... I am stumped.

A lot of shifters require you back the tightening bolt completely out of the shifter as an extra step for it to come off in case it comes loose while riding.

[Jizmeister]

Misc's opinion on Hyosung?

I'm getting my license soon and I'm not ready to buy a bike yet, but was going to rent one for a day. Either the cruiser or the sport version.

Any good?

Bump

[Great_Story_Bro]

http://forum.bodybuilding.com/showth...hp?t=162122921

[PlGinge]

Hey thread,

I am trying to replace my rearsets on my '08 Honda CBR125r - I have the replacement part all ready to go but i can't figure out how to remove the shifter arm from the rearset on the left side. Any chance someone knows how to remove it?

I thought maybe it would screw on, but nope, i think maybe its some kind of clip or something... I am stumped.

It'll most likely have a little circlip that you need to remove before the gear rod will pop off from the rearset. Hard to explain without a picture of the clip I guess. You literally pop it off and then pull the pin out of the connecting part and it should pop off.

[recreateme]

It'll most likely have a little circlip that you need to remove before the gear rod will pop off from the rearset. Hard to explain without a picture of the clip I guess. You literally pop it off and then pull the pin out of the connecting part and it should pop off.

Yeah, that sounds about right. I can see a circlip on the outside. How exactly do i pop that off in a manner that will allow me to reuse it when i re-install it ?

[_Muskelberg_]

started new thread with sexiest bike

ending old thread with ugliest bike

[PlGinge]

Yeah, that sounds about right. I can see a circlip on the outside. How exactly do i pop that off in a manner that will allow me to reuse it when i re-install it ?

Find the end of it, and just flick it back and it should pull out. I've never had an issue re-using any of mine.

[Reef58]

Bump

The reviews I have read have not been so good.

[Dirk__Diggler]

Locked