|
Closed Thread
Results 8,131 to 8,160 of 8698
-
03-30-2020, 05:04 PM #8131
- Join Date: Oct 2003
- Location: New York, United States
- Age: 68
- Posts: 19,925
- Rep Power: 10376
-
04-01-2020, 07:16 PM #8132
I think the reason the eccentric part of my barbell calf raises on a board isn't working well is because I always have to lean forward with the bar to get some support from the power rack. If I don't do this, I will probably fall off the board and it would be too tough to do a proper calf raise. This makes the eccentric part of the raise less effective for me since I'm lowering the bar with while it's supported by the power rack in front. I started doing the bodyweight eccentric heel drops. I'll check back in with the results (hopefully not a torn achilles)
-
-
04-04-2020, 09:29 AM #8133
Thoughts on lowering the rep range by 2 or 3 to acheive more strength without stepping into power lifting territory?
To me this workout looks slightly more hypertrophy and not as much strength training. I'd like a routine that is inbetween strength and hypertrophy training, so thought just by lowering the reps by 2 or 3 I could acheive that?
Eg:
Week 1: 6 reps
Week 2: 7 reps
Week 3: 8 reps
Week 4: 9 reps
Week 5: 10 reps
Yes, I am well aware it says not to modify it, but I remember reading All pro somewhere in the older thread (years back) that changing the reps would be ok. Just curious to what people in here would think of that with my goal in mind?
I think what I am after is a powerbuilding routine, however, I like the exercises within this one and how it works.
Thanks
-
04-05-2020, 12:02 PM #8134
Lowering the reps by 2 or 3 will increase the working weight by 3-5%, and reduce tonnage lifted per session by 20-25%.
Technically even 3-7 reps works with the allpro pattern, but at some point there will not be enough tonnage lifted in 2 work sets to push progression.
6-10 works too, it just means you will hit the volume wall sooner and will need more accessory work.
Hell people on the traditional 3x5 programs can hit the volume wall in 90 days.
Its perfectly ok, but you really need to think about your goals.
"Carry over" is important. You are going to be "strong" in a range that is +-15% of your training weight. You are not going to be power lifting if you are always training in the 5-10 rep range. Even a 5 rep grinder is a bit over 80% of 1rm, so if someone puts 100-102.5% on the bar, you wont be able to do it even if the math says you can. Like wise someone who does 3x3 at 90% of 1rm training, is not going to be able to do 10 reps at 70%.
Technically even 3-7 reps works with the allpro pattern, but at some point there will not be enough tonnage lifted in 2 work sets to push progression.
-
04-06-2020, 10:40 AM #8135
-
04-06-2020, 01:08 PM #8136
Greyskull LP is what i recomend after allpro. Once you can bench 10 reps of bw at 13% bf bmi 24, and squat 1.25-1.5x bw for 10 reps. Around that time allpro becomes too fast, and does not have enough tonnage to push progression.
Greyskull LP properly programmed could be ran for life. Its main feature is the ability to take a 4 plate deadlift to a 5 plate deadlift in about 18 months, with equal gains for the rest of the main lifts as well.
Now grey skull is a bit missleading when you think of it as inbetween hypertrophy and strength. Ideally core greyskull is 2 RPE 6-7 sets and 1 RPE 10 set. This is normally 2 sets of 5 and a set of 8-9. "The other half" of the volume of the program is programmed by you, for your goals. The "/fit" variant is a pretty good core. Phraks kinda sucks and i dont recomend it, its was made by a guy who never squatted 3 plate in his life, and just used it to help with his massive calisthenics routine. Properly programmed for an intermediate greyskull should take around 1.5-2 hours per session.
-
-
04-06-2020, 02:29 PM #8137
adding single arm farmer carry & turkish get up to All Pro
Hi - love these threads. thank you so much for posting this. I've been at All Pro for 5 5-week cycles now and am loving it. Progressing well
S - 170
BP - 175
BOR - 187.5
OHP - 100
SLD - 147.5
Upright row - 90
Calf raise - 155
also training for a marathon currently
Been lifting 3 days week and running 4. I'd like to incorporate farmers walks and turkish getups somehow. I've been thinking of adding some kind of "alternative lifting day". I don't want to mess up All Pro, but something to change it up.
would you recommend for farmers walk / turkish get up
a) adding a day? if so when? after light day?
b) adding to existing All Pro day? where in the routine?
c) replacing an all pro lift?
how often or how infrequent? currently thinking once per week
thanks much in advance
-
04-06-2020, 02:39 PM #8138
-
04-07-2020, 07:17 AM #8139
-
04-07-2020, 02:18 PM #8140
With everyone in quarantine are there any additional workouts I could add? I am doing everything as I normally would do but without being able to get out of the house at present is there anything else I could add? I already do 10km static bike ride 3x a week but feel like I'm adding on a little fat. Cheers
-
-
04-07-2020, 03:01 PM #8141
-
04-07-2020, 10:23 PM #8142
-
04-08-2020, 01:54 PM #8143
-
04-09-2020, 09:14 AM #8144
I have another question - I've not been progressing on bench press - what should I do if I want to make progress? I'm on my 5th cycle - everything else is going up but bench press is stuck at 175 lbs (where it was beginning of week 1) I'm getting 21-22 reps on test days.
-
-
04-09-2020, 09:26 AM #8145
What is your height, bw, and body fat? 175lbs is pretty close to the end of the program if you weigh around 175lbs.
At that point you will need 50-100% more volume to push progression, and the progression pattern needs to be flexible enough to allow for 10% progression per year.
-
04-09-2020, 11:11 AM #8146
I'm 6'1", 189lbs, 10-11% body fat.
Not sure if my weight being 10% over 175 changes your answer, but when you say 50-100% more volume should I be adding a set (or two) to my bench? so all other lifts are 2 sets, but I'd do 3-4 for bench?
Just for some additional context on myself - I have done on again off again weight lifting before, and bench press probably was the most consistent lift I kept over the years. So I'm not surprised its the first of the 7 lifts to plateau. But please do let me know how you think I could keep progressing on bench (since I'll eventually hit plateaus on other lifts sometime too)
-
04-09-2020, 12:11 PM #8147
-
04-09-2020, 01:19 PM #8148
My squat isn't so great! Currently at 170 lbs - have been passing easily the last 4 cycles. Started light (115 lbs) because my low back was bugging me and wanted to give core and everything time to get strong. Currently (knock on wood) no low back issues. Did 170x8x2 5 days ago and felt strong, thinking I should pass 170x12x2 too.
Oh wow to that math! I've never tried to do my one rep max, but 280 seems insane for bench haha. Maybe I should try sometime
OK - any recommendations for what to do with my bench if its at the end of the program? Sorry if this has been already asked and answered somewhere. I do really love this program and would like to keep it for the other 6 lifts.
-
-
04-09-2020, 03:17 PM #8149
-
04-09-2020, 03:30 PM #8150
If you want to mix it up a bit, you can try my 10 set of 3 pattern.
Bench using your current working weight for sets of 3, with 30 seconds of rest. Stop when you get a slooooooow rep with good form. If you get all 10 sets, next session add 5-10% more weight, enough to knock you back down to 5-6 sets. If you get really good at this pattern, you will end up with 30 reps of 80-85% of 1rm, in about 8 minutes.
-
04-09-2020, 03:40 PM #8151
-
04-09-2020, 04:46 PM #8152
-
-
04-09-2020, 04:47 PM #8153
-
04-10-2020, 08:00 AM #8154
I'm on my 1st cycle week 2. If I can't get my light workout in today should I do it tomorrow (Sat) then continue with my week 3 heavy on Monday or should I skip the light day?
-
04-10-2020, 11:04 AM #8155
-
04-12-2020, 05:21 AM #8156
Is there any harm in replacing the bent over row with an incline chest supported barbell row?
-
-
04-12-2020, 06:12 AM #8157
-
04-12-2020, 07:28 AM #8158
-
04-12-2020, 07:42 AM #8159
-
04-15-2020, 01:36 PM #8160
Hi,
new here, after reading this thread for a while i decided to start with this program, and i have some questions
i am lifting weight for few month with not so good progress
age: 30
weight - 59kg (130lbs)
height - 170cm (5'7")
i consider myself as "skinny-fat". i pretty skinny on most part of my body, except my stomach that have some fat and really sticks out
so i would say i definitely not 15% BF, i'd say somewhere close to 20%
my questions:
1. my goal is to lose fat and gain some muscle and get rid of my belly, and not have the "skinny fat" look anymore
is this program good for me? any special consideration i should take rather than staying at a
calorie deficit?
2.regarding nutrition - i understand that my intake should be about 100g protein/fat, 200-300g carb. the thing is, when i use the TDEE calc it says that i need to eat around 1200 calories for fat lose.
it looks like a really low calorie diet, and i have a hard time getting the right amount of proteins i need
i was on a calorie deficit diet for about 2 months, with about 1400-1500 calories i did not see any weight/fat loss(making me believe that the TDEE calc is right).
what should i do?
3. my calves are pretty weak, it's the first time i will train this muscle, and it seems that i'm currently cannot do standing calves raises with more than my bodyweight with good form.
how should i calculate my progress?
Bookmarks