Forum: Workout Equipment

Hi all, not a specific equipment question but asking what people's thoughts are or if anyone has done this before. I recently bought a Dual Cable pulley machine from primal strength (can't attach link as not enough posts) to be delivered end of Feb. I hadn't seen the additional information bit...

Sorinex Safety Squat Bar $350 EliteFTS Safety Squat Bar $425 Can someone provide feedback between these two bars? Everything I could find when searching seemed outdated because people were saying the Sorinex bar was overpriced at $616 - it seems they've since changed their pricing. Anyway,...

I'm reviewing the X-Training Weightlifting Bar found here: https://www.xtrainingequipment.com/XOB-Barbell-20kg I got this bar for $119, shipped, during a flash sale before Black Friday. I got it to replace my bent generic bar to use in my power rack. I'm writing this review to give people...

I'm looking to replace my cheap curl bar with a good one that compliments the rest of my gear. I know basically every retailer is out of stock right now, but occasionally some pop up in stock for a very short period. I'm hoping to jump on that or possibly find a used bar. Most any high end bar...

Yes I realise this will be a totally stupid question but here goes anyways. When you say how much you bench/lift it is the combination of both sides, so say you have 5kg on each side you would say 10kgs. Is this the same as with the fixed weight barbells? If I was using a 10kg (on each side)...

Hey, folks. I've checked these boards every now and again over the years and decided to register so I could run some questions by the community. I'll likely stick around. That said, been on the hunt for some plates and extra equipment in this now starved market. I wanted to get my hands on Troy's...

I need a square plastic bushing for a Star Trac preacher curl. Full Circle Padding lists the dimensions of the part as 2" x 2" OD, 1.5" x 1.5" ID. Unfortunately, prices on this piece range from $81-103. NFW I am paying that. Anyone know where I can source something workable for <= $20? I can...

I have a few questions about Ivanko OMs, after flipping items and making some quota when normalcy returns once again I was thinking of perhaps matching my plates suits with my O2Bs and who knows maybe at some point replace all those with OMs (credit to vhd for the suggestion). With that I have a...

I finally got to use my new IM Ultimate Row Handle on back day this morning. My initial thoughts are that it could easily replace several attachment handles, like a wide grip or medium grip pulldown handle, a V Bar pulldown, a "U" shaped low row handle, wide and medium grip parallel pulldown...

Only a few bars. Currently lean them into corners but looking to buy or make a rack. Vertical hang option seems like it will take up less room (if that makes any sense?) but horizontal may look cooler?