Shermworks Halfers (microloading plates) Review

[owasM]

anyone know if 2" washers are sold in the u.k? i have never seen anything above 1".

could do with welding some for inner collars.

[morebarbell]

I don't know but in the US we also have washers in those wacky metric sizes. I think M50 is roughly a 2" center. 2" = 50.8 mm I've seen up to M78 (that's a BIG washer!).

anyone know if 2" washers are sold in the u.k? i have never seen anything above 1".

could do with welding some for inner collars.

[ProtienandIron]

anyone know if 2" washers are sold in the u.k? i have never seen anything above 1".

could do with welding some for inner collars.

I've been looking for them for years mate, no luck so far.

[morebarbell]

I could send some to you guys but I think the cost of shipping would be ridiculously high.

[owasM]

I could send some to you guys but I think the cost of shipping would be ridiculously high.

i was actualy going to ask if someone could,
i doubt it would be more then the price of laser cut washers (seems to be the only option)
around how much would 4 weigh? i'm guessing they'd fit into a small jiffy bag.

[morebarbell]

If you figure out a way that works, let me know. It seems that it would cost a lot but I'm not very familiar with international shipping. Here's the online rate calculator... http://ircalc.usps.com/?country=10150

i was actualy going to ask if someone could,
i doubt it would be more then the price of laser cut washers (seems to be the only option)
around how much would 4 weigh? i'm guessing they'd fit into a small jiffy bag.

[sherman]

i was actualy going to ask if someone could,
i doubt it would be more then the price of laser cut washers (seems to be the only option)
around how much would 4 weigh? i'm guessing they'd fit into a small jiffy bag.

The cheapest shipping for a max of 4 lbs is $23.95. Since the washers weigh about .62 lb each, the max under that limit is 6 washers. The next step up is $60 for 20 lbs, washer limit about 30. From reading the posts an checking around, the washers are easy to get for $3 each, and maybe less if a cheap source is found. Not guarantee on the exact weight of the washers. Under the spec there can be 40% weight variation from The lightest to the heaviest. The ID is 2.125"/54 mm

For halFERs it would work out like this at $3.75 per plate.

4 lbs limit - 8 plates x 3.75 = 30.00 + 23.95 shipping = $53.95 or $6.75 per plate

20 lbs limit - 38 plates x 3.75 = 142.50 + 60.00 shipping = $202.50 or $5.30 per plate
(38 plates because allowance needed for box.)

If you want, I can help. Maybe get a joint buy for you and IP.

[daniel327]

I've been looking for them for years mate, no luck so far.

I could mail you some.