Search:

Thanks fellas. Im going to get some funky colors on all the equipment that im dropping off to the powdercoater. Mostly red with the neon green thats on your everyday tennis ball. I know it sounds...

Finally had a chance to put some work in on my yoke. I basically made what Sorinex called the "Yoke of Goergon" but they discontinued it. It's 3x3 and 1/4" thick from top to bottom. Need to make some...

I guess if it aint broke dont fix it so i'll stick with this version. I like the way the area51 jack looks also but they must have had to test it out before selling these. I must say that they have...

Exactly what I did. Considering that your jig is spot on you'll have less room for error. I just used a 3/8'' bit to make a pilot hole and went behind it with a magdrill to make them 1". I even did...

[QUOTE=BAVE;1052813021]A custom piece from BWTG for my EliteFTS 3x3: pair of rack mounted platforms for belt squats. I plan to cut a piece of stall mat rubber for each one and they'll also be used...

I need to add a belt sander to my tool collection. It sure would save me a lot of time trying to cut angles into stuff. I put together some very similar to yours a few days ago
...

How'd you bend that Vbar?

Thanks, hopefully I'll be done this weekend if I can squeeze in the time. I have about five projects in the works and will be headed to the powdercoater as soon as the yoke is finished.

No 2boysdad, I sold my powertec and am currently working on a heavy duty yoke. Everything will be 3/16'' and 1/4''

this is what im going for but heavy duty
http://youtu.be/q5qZ_dftCQ0

Those tct cutters are nice and I think for a small amount of holes you could really use anything you can get your hands on. What are you working on that needs holes?

I think the best way to do it is to borrow or rent a magdrill like I did. I tried to use a step bit with a hand drill and after 5 holes I gave up. The drill press with a hole cutter at a friends shop...

Thats a nice bar!! If one inch is good on that bar it should be for me too.

Thanks

Quick question! Whats the most common size for the handles on trap bars? Im making one out of some left over metal and all I have left is some 1'' solid pipe. You guys think that's a sufficient...

How goes it Matrix??? What are you thoughts on the BOB so far? Should I skip it and just get a heavy bag? Im looking for something just to add to my arsenal at home...

[QUOTE=AttyGuy;814085351]Bump, because I finally figured out how to get sand into the B.O.B. base.[/QUOT

You guys have any extra input on the Century B.O.B. as far as its usefulness in...

This reminds me. I joined up with them about 4 years ago and I lasted one full day before I canceled my membership. I never did get my deposit back...

The uprights are easier and thats only because you can push at a lower postion. Im pretty strong and it was pretty ruff with 2 45's on the sled in the grass so I opted to only use it on concrete at...

It only helped with the leverage issue when pushing with the lawnmower handles. Before I cut them it would always lift from the side being pushed especially on grass. I did notice that most of the...

I made two of these sleds off the measurments from their website and ended up cutting them down shorter cause I noticed the same issue with the weight centered. Its very difficult with the sleds on...

I see this one locally for $125. It says its for a 3'' wide and 2-3'' deep uprights. Looks good to me...

http://i755.photobucket.com/albums/xx194/slimneverdies/photo3-1_zps3495e1d3.jpg...